D&D Plastering
Iron County · Parowan, Utah

Stucco contractor in Parowan.

Three-coat traditional, EIFS, repairs, and custom finishes, applied by hand. Serving homeowners, custom home builders, and general contractors in Parowan since 2001.

CountyIron, UT
TradeStucco / ST
Scopes6
Working since2001
37.8425° N · 112.8300° W · Iron Co. · 84761
ST-84761

Working in Parowan

We know Parowan walls.

Parowan is the highest and coldest town covered here, at 6,155 feet in Iron County, climate zone 5B under Utah's adopted residential energy code. That is roughly 2,800 feet above Toquerville, and it compresses the cement stucco season hard at both ends. Portland cement stucco has to stay above freezing for days after it goes on while it hydrates, and at this elevation the nights that satisfy that condition are a narrower band of the year than most homeowners expect. Once the wall is up, the same elevation means the highest number of freeze-thaw cycles of any town in this group, and every one of those cycles works on water sitting in a hairline crack or behind a poorly drained wall. Parowan also has a long masonry history to look at: the sandstone Parowan Meetinghouse, begun in 1862 and listed on the National Register since 1976, was built from stone quarried in the nearby canyons.

The season drives everything in Parowan. We plan the exterior sequence around the cure window rather than fitting it in wherever the schedule lands, and we front-load prep, lath, flashing and penetrations so the wall is ready when a workable stretch of weather arrives. Application stops when the overnight forecast will not hold above freezing across the cure. Marginal weeks get protection and heat or they get pushed. On the wall itself, we detail drainage aggressively because freeze-thaw punishes trapped water more here than anywhere else we work: continuous drainage plane, correctly placed weeps, and joints laid out to the framing.

Elevation6,155 ft
Climate zone5B
PermitsParowan City Building Department, online. Parowan no longer uses Iron County.

Around town: Parowan Gap, pioneer-era Main Street, Brian Head access

ST-01

Other trades in Parowan

Three more trades, all in-house.

Stucco scope

A complete scope.

A finish coat lasts thirty years when the lath spacing, brown coat hydration, and corner detail are right. Most failures aren't about the finish, they start in the layers no one sees.

  • 01Traditional 3-coat stucco
  • 02EIFS systems
  • 03Stucco repairs and matching
  • 04Custom finishes & textures
  • 05Color coat application
  • 06Foam shapes & cornices
About our stucco work
ST-04

Parowan questions

Asked in Parowan.

Specific to stucco work here, not general questions about working with us.

Does Iron County still do Parowan's building inspections?

No. Parowan City no longer uses Iron County for its building permit and inspection process and now runs its own building department, and the permit process is entirely online. That is a change worth knowing about, because older guidance and third-party permit sites still point people at the county. City offices are at 35 E 100 N. Property outside the city limits does still go through Iron County. If you are not sure which side of the boundary a parcel sits on, check with the city before you submit anything.

When does the stucco season close in Parowan?

There is no fixed date, but it closes earlier than anywhere else in the region we cover. Parowan is at 6,155 feet in climate zone 5B, and cement stucco needs several days above freezing after application to hydrate properly. A coat that freezes before it sets is permanently weakened, and it will not be obvious until it starts failing. We track the overnight forecast for the full cure period on that specific site and make the call week by week. When application is off, prep, lath and flashing can still go ahead so the wall is ready.

Why is Parowan harder on stucco than St George?

Elevation and climate zone. Parowan sits at 6,155 feet and Iron County is climate zone 5B, while Washington County and the St George valley are 3B. That means a much shorter window when a coat can cure safely, and once the wall is finished it goes through many more freeze-thaw cycles per year. Freeze-thaw is what turns a hairline crack into spalling: water enters, freezes, expands, and widens the crack a little each time. A detail that is adequate in St George can be marginal on the same house built in Parowan.

Get a free quote

Tell us about your Parowan project.

We respond within one business day with a site walk, a sample, or a line-item estimate.

435-229-3769
ResponseOne business day
HoursMon-Fri, 8am to 5pm